Messages

41

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 04:28:18 PM »

Hood can it be because my inpus is not in seqence.

42

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 03:01:23 PM »

Hood I even tried to Use iunput 1 to4 in the place o OEMtrigger1 to4 with the same result no output.

43

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 02:56:08 PM »

It is a ratched type turret.When it reverses it locks the turret.

44

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 02:52:46 PM »

I have disconnected the revers relay just to see if the relay was the problem.

45

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 02:50:16 PM »

Hood output4 drives a relay to turn the turret.When this relay falls away another relay comes in at a lower voltage and reverses the turret. This is hard wired.

46

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 02:35:27 PM »

Hood the previous reply should have been brain.I tested it with a brain program and with that it is working (the OEM TRIg).

47

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 02:26:12 PM »

Hood  the turret reverses to lock.You can hear the turret going past the locking pointand then it must reverse. The OEM triggers is working I tested it in a brisn brogram.

48

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 11:19:42 AM »

Hood if I switch the oem trigger inputs off and i switch the input 1 to4 on I can see my inputs from the turret, it will only change as it gets to the next tool.They are set at active low but i have played with it setting it active high.

Cj

49

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 11:14:13 AM »

Hood where do I see the oemtrigger leds

50

General Mach Discussion / Re: Running macro and testing them

« on: May 10, 2008, 11:12:21 AM »

hood I see that you have taken one line and switched it Off I presume that the probleme is there."If oldturretpos<>nexttool then"