1
General Mach Discussion / Mach3 and external motion controller
« on: September 03, 2014, 10:28:48 AM »
Are there any external motion controllers available that do not display the feedhold / feed override lag.
Just sent my uc100 back for a refund due to a 2.5sec delay after pressing feedhold or feed override buttons.
I know this is because of the communication buffer length emptying.
So is there anything else that does not display this problem??
Just sent my uc100 back for a refund due to a 2.5sec delay after pressing feedhold or feed override buttons.
I know this is because of the communication buffer length emptying.
So is there anything else that does not display this problem??