31
General Mach Discussion / Spindle problem
« on: July 22, 2006, 06:11:05 PM »
I recently made a mini router .Everything works fine except spindle on-off function. I set up pin 17 as output pin for the spindle.Sometimes I measure 2 volts sometimes 4.45 volts on pin 17 . I don't know why it is not stable . even sometimes spindle runs during the jogging .I use mach 3 running on my PIII 800 mhz laptop . I use solid state relay and opto isolated amplifier pcb for the spindle. Sometimes the signal is so weak that spindle runs jerky( due to frequent on-off ) .Does anyone have a problem like this ?
rceebuilder
rceebuilder