Messages

101

HiCON Motion Controller / Re: Rigid Tapping

« on: January 09, 2018, 03:51:31 PM »

The rigid tapping feature requires an activation code to be purchased in order to use it. The feature can be activated using the VSI device manager. If you provide us with email address we can send PDF manual on using HiCON rigid tap in Mach4.

102

HiCON Motion Controller / Re: Rigid Tapping

« on: January 09, 2018, 02:39:25 PM »

The HiCON Integra 7766 has one differential encoder input next to the relay and DAC I/O where the spindle connects. There is also a single ended encoder input located on the board near the MPG port.   

103

dspMC/IP Motion Controller / Re: Motor tuned well in dspMC plugin but not when commanded by Mach4

« on: January 07, 2018, 06:49:30 PM »

you can send your mach4 profile to support email and we will test it.  go to help menu and select package current profile and email the .m4prof file.

104

dspMC/IP Motion Controller / Re: Motor tuned well in dspMC plugin but not when commanded by Mach4

« on: January 07, 2018, 05:25:38 PM »

did you try restart mach4?  sometimes the vel/accel changes do not take effect right away.   Restart mach4 and verify motor tuning setting.  hope this helps.

105

dspMC/IP Motion Controller / Re: Spindle analog signal

« on: December 13, 2017, 02:08:24 PM »

We found that the M3/M4/M5 macros in your profile were corrupt.   once they were deleted from the macros folder, the spindle analog voltage started working.

106

dspMC/IP Motion Controller / Re: Spindle analog signal

« on: December 13, 2017, 11:27:36 AM »

please email the profile to support@vital... and we will check it.  go to mach4 help menu and select package current profile and email it. 

107

dspMC/IP Motion Controller / Re: Spindle analog signal

« on: December 13, 2017, 01:20:00 AM »

What is the plug-in and dspmc firmware version in your system?

108

dspMC/IP Motion Controller / Re: Wrong Motor Moving

« on: December 12, 2017, 02:34:08 PM »

please package your mach4 profile and screen and email to support.  will check it out.  thx.

109

dspMC/IP Motion Controller / Re: Wrong Motor Moving

« on: December 11, 2017, 11:41:22 PM »

Try this config:

X Axis assigned mMotor (0)
Y Axis Assigned Motor (1) as master, Motor(3) as slave
Z Axis assigned Motor (2)

110

HiCON Motion Controller / Re: 7766 / Mach4 Homing issue

« on: November 20, 2017, 07:35:20 PM »

You may need to upgrade the firmware on the controller. The latest release is 3.58

You can use the VSI Device Manager to upgrade the firmware on the controller

The software and instructions can be found on the Vital Systems web site