Messages

11

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 10:15:38 PM »

I started a new profile with default settings and set up pins, hot keys and port to keep it clean.

http://67.11.148.170/router.xml

Looking at it (the XML).. it looks like all the ports, pins exec.. are set correct.

12

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 09:55:10 PM »

No that did the same thing Brian.

I was looking in the XML and it shows all 0's for all the output ports.. Hmmmm.

I'm a fair programmer, with a hint I can play around and find it... But I'm sure others may have the same problem.

13

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 09:25:31 PM »

The Mach3mill.xml ? That is the one I have setup.

That is a huge file ?

ok here it is on my server,,

Thanks

http://67.11.148.170/mach3mill.xml

14

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 09:12:52 PM »

Oh and this is a purchased copy not the demo version, so that can't be an issue.

15

General Mach Discussion / Re: Mach2 works fine but...

« on: May 12, 2006, 09:11:00 PM »

I'm not sure the XML for your machine would help me out, as I'm running a home built router table with Geko 201 drives connected to a parellel port on my computer.

I have tried everything.. and Mach3 just wont talk to the port or port(s) for that matter. I used a port monitor and can see Mach2 changing status but Mach3 wont change any of them except if I force all pins high Mach3 will set them all low on startup but that is as much port activity as I can get out of it.

I'm sure it must be something simple that i'm missing in the program 

16

General Mach Discussion / Mach2 works fine but...

« on: May 12, 2006, 08:38:53 PM »

Mach3 won't with all the same port settings.
It looks like it works but it's not getting to the port 

I'm running..
P4 2.8 gig
XP Home

Any ideas?