1
General Mach Discussion / Re: Exact homing
« on: May 11, 2006, 02:57:57 PM »If you have encoders with the index pulse then this can be used to set exact zero point.
Mach will not do this for you, you have to write a visual basic script for the homing. (Or will it Brian)
Graham.
Graham:
Do you mean connecting the encoder to the input pins and write a program in VB to get the ABSOLUTE "0" position ?
It sounds good.. I will check if this is possible.
Do you know any Encoder model that have output signals other than the used to connect to the driver ?
Regards,
Victor