Messages

841

General Mach Discussion / Re: Problem activating input switch on the diag panel with the mouse

« on: October 27, 2010, 04:06:43 PM »

 

842

General Mach Discussion / Re: Problem activating input switch on the diag panel with the mouse

« on: October 27, 2010, 03:31:31 PM »

Have a look at this video, it will give you an idea what Home switches are.

http://www.youtube.com/watch?v=2v5tCda3lZE&feature=related

Dave

843

Show"N"Tell ( What you have made with your CNC machine.) / Re: Cylinder Heads

« on: October 26, 2010, 08:19:00 PM »

Just some really impressive work there, Steve-

Dave

844

General Mach Discussion / Re: Problems with Parallel Port inputs on Motherboard not working

« on: October 26, 2010, 10:44:57 AM »

Have you tried switching the cables on the bad axes with the known working cables to see if the X and Y will run? Possibly you do not have your pins set up correctly?

Dave

845

General Mach Discussion / Re: Setting up the taig cnc micromill 2000 to work with mach3

« on: October 22, 2010, 05:11:07 AM »

St, John,

Make sure you're downloading the correct xml as I believe there's quite a difference between xml's for the Taig 2000 and the Taig DSLS 3000 systems.

I'm not at all familiar with the 2000 system but it is not the same controller setup at all as the 3000 and with the 2000, I think you need some sort of "pulse- adapter" to run the 2000 with Mach 3. Don't quote me on that, but I'm remembering something to that effect 

Dave

846

Forum suggestions and report forum problems. / Re: Mach 3 and Yaskawa Servos

« on: October 21, 2010, 04:54:24 AM »

hi im new to MACH 3  controller users , i neet to knoe if i purchase the controller for plasma & oxy cutting machine i can directly use the controller or i need to do any modifications in contriller ?
and what are the modifications need to be done ,step by step procedures ,please

Hello, you posted your question in the : Forum suggestions and report forum problems.

You should start your own topic and post it in the "General Mach Discussion" area part of the forum.

Thank you,
Dave

847

Show"N"Tell ( Your Machines) / Re: spindle motor

« on: October 10, 2010, 04:19:25 PM »

Ger, could you pass on the link on the zone, please?

EDIT: Found it:  http://www.cnczone.com/forums/diy-cnc_router_table_machines/112658-super-pid_new_low-cost_router_speed_controller.html

Thanks,
Dave

848

General Mach Discussion / MOVED: PLC

« on: October 08, 2010, 01:27:36 PM »

This topic has been moved to Bargain Basement.

http://www.machsupport.com/forum/index.php?topic=16160.0

849

Show"N"Tell ( What you have made with your CNC machine.) / Re: spindle

« on: October 08, 2010, 05:08:12 AM »

You should really post your question only once.

Please also post your questions in the approriate forums.

850

Show"N"Tell ( Your Machines) / Re: 1987 Bridgeport Production Center Interact 412 to Mach3 Conversion

« on: October 05, 2010, 09:15:43 AM »

I'm guessing an arcade game supplier?

Dave