651
General Mach Discussion / Re: micro control with keypad
« on: August 03, 2011, 11:16:19 AM »
Hello, tc,
The manual explains this better than I could. It's on page 3-5 of the "Using Mach 3 Mill" manual. Under the Heading 3.3 "Jogging"
Basically you can set it up so that you can move any distance you want using the Jog control in the increment/step setting.
Dave
The manual explains this better than I could. It's on page 3-5 of the "Using Mach 3 Mill" manual. Under the Heading 3.3 "Jogging"
Basically you can set it up so that you can move any distance you want using the Jog control in the increment/step setting.
Dave