Messages

2251

Finished Screens / Re: Chucks – LED City set

« on: March 23, 2008, 09:39:07 AM »

Chuck, you're an artist, my friend and this is a wonderful screen set, thanks so much for your hard work 

2252

Mach SDK plugin questions and answers. / Re: Shuttle Xpress Problem

« on: March 21, 2008, 09:46:12 PM »

Hi Brian, no sir, I have optimised my machine (microproto dsls 3000) and with a gamepad it works perfectly using keygrabber but thought I'd like the functionality using the Pro. Also, I followed the instuctions to the "T" and did not install the drivers.

2253

Mach SDK plugin questions and answers. / Re: Shuttle Xpress Problem

« on: March 21, 2008, 09:11:59 PM »

Installed my shuttle pro today and I'm a bit disappointed as when I set the buttons for the x, y, and z axis, they sometimes "stick" and when I let off the button, it stills goes for a bit but not all the time. In a other words, if I want the table to move just a bit, I push down on the button and let off the button and it will stop but the next time I do it, it will keep going when I let off then stop itself after it travels a bit. It's very inconsistant as well.

Is anyone else experiencing this? It's very un-nerving to say the least as I'd like the table to stop immediately-

2254

General Mach Discussion / Re: ScreenTweak hotkey utility

« on: March 16, 2008, 12:10:45 PM »

lol, thanks again-

2255

General Mach Discussion / Re: ScreenTweak hotkey utility

« on: March 16, 2008, 11:52:50 AM »

Thanks so much, my friend but that looks to be release B1.0 where as the wiki info says it should be "Rev C1 onwards". Do you happen to know how to contact John Prentice?

Thanks again - 

EDIT: would it be "japrenticeuk" ?

2256

General Mach Discussion / ScreenTweak hotkey utility

« on: March 16, 2008, 11:00:05 AM »

Is this still available anywhere? Tried to get it from wiki but no website is to be found-

2257

General Mach Discussion / Re: New Guy...Need Help

« on: March 12, 2008, 07:34:01 PM »

Glad to be of help- 

2258

General Mach Discussion / Re: New Guy...Need Help

« on: March 12, 2008, 04:44:22 PM »

Emtffkev, make sure you close the file in autocad before importing it into lazycam as it will not import until you do so. I had this same issue-

2259

LazyCam (Beta) / Re: Multiple Pockets

« on: February 24, 2008, 09:08:05 AM »

RC, I tried your dxf and while I've also had problems with LZCam, this one didn't seem to be a problem at all. I've gone back to Rev. 2.61 so maybe that has something to do with it? I'm including a screen shot and my connection tolerance is :  Connection Tol.:0.001000 units

I did not use single/multiple, I just picked each pocket one at a time-

2260

General Mach Discussion / Re: Need Z to lift out of part when we pause or stop machine How ????

« on: February 06, 2008, 04:58:28 PM »

good info, thanks!