2241
Mach SDK plugin questions and answers. / Re: Shuttle Xpress Problem
« on: May 01, 2008, 03:50:00 PM »Quote
Installed my shuttle pro today and I'm a bit disappointed as when I set the buttons for the x, y, and z axis, they sometimes "stick" and when I let off the button, it stills goes for a bit but not all the time. In a other words, if I want the table to move just a bit, I push down on the button and let off the button and it will stop but the next time I do it, it will keep going when I let off then stop itself after it travels a bit. It's very inconsistant as well.
Is anyone else experiencing this? It's very un-nerving to say the least as I'd like the table to stop immediately-
This weekend I will see if I can get some time to un my router and test the shuttle.. You are the econd one that has reported this but I have not seen it I will be testing with Rev 3.038 and I will tell you if I find anything.
Thanks
Brian
Brian, any chance you had a look at this? I went out and bought a brand new Shuttle Pro 2 and it's doing the exact same thing as mentioned above.
Thanks for your time-
Dave