2191
General Mach Discussion / Re: Labeled my Shuttle pro...
« on: June 15, 2008, 06:04:11 PM »
thanks fellas-
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
This is one of the sample tool paths from the 'Vectric Cut2D'. It makes a very nice job but there are so many unnecessary and time consuming Z moves on such a simple plaque that I really wonder how well it will cope with a complicated design.
Jim,
That reply should be a sticky at the top of the page! I wish someone had made it that clear when I was begining to figure out the G-code a month or two ago.
Kristin