Messages

2091

General Mach Discussion / Re: Where did my setup file go?

« on: July 30, 2008, 06:46:11 PM »

Yes, definitely, just save the whole folder and then if anything goes wrong, you can just pick out what you once had and use it. 

I do this because I have made my own screen sets and macros so I figured just do the whole thing and be done with it. Storage is so cheap now. 

2092

LazyCam (Beta) / Re: LAZYCAM toolchange problem (bug) - reporting

« on: July 28, 2008, 06:44:57 PM »

Success! Thanks again, Chip -   

2093

Finished Screens / Re: Ultimate Screen Mill/Lathe/Plasma (TouchScreen and/or Mouse and/or keyboard)

« on: July 28, 2008, 03:44:04 PM »

Very nice looking stuff but check out the "Tool Advance" area. You have a button spelled "remeber". I believe you meant "Remember"? 

Dave

2094

General Mach Discussion / Re: Output Pin Problem

« on: July 28, 2008, 02:06:26 PM »

Indeed, I'm reading up on it now (pdf manual online). Thanks for the heads up-

Dave

2095

General Mach Discussion / Re: Output Pin Problem

« on: July 28, 2008, 01:47:39 PM »

Hey now, that's very interesting. It was a bit more than I'd hoped but jeez, look at all those I/O's!!!   

Thanks as always!
Dave

2096

General Mach Discussion / Re: Limiting motor acceleration

« on: July 28, 2008, 01:14:45 PM »

Nah, Jim, I don't think our comments were meant that way, I think once you do finally run out of your demo amount, you'll be happy to contribute to this software, no?

2097

LazyTurn / Re: LazyTurn

« on: July 28, 2008, 01:11:50 PM »

Then I did understand it completely (for once  ) and I thank you for taking the time to share that -

Dave

2098

General Mach Discussion / Re: Limiting motor acceleration

« on: July 28, 2008, 12:08:28 PM »

I coiuldn't agree with you fellas anymore, for the price of Mach3, it's an act of thievery to not buy it 

2099

General Mach Discussion / Re: Output Pin Problem

« on: July 28, 2008, 12:05:38 PM »

Olf, I'm really not sure what to use now but Hood speaks highly of the PMDX 122 and I've also heard many good things about the Boards from Bob Campell. These seem a little overkill for what I want as I was hoping to get away with a lower price as I'm not hooking up any motor drivers to the board that I'd be getting, I just want more I/O s for relays and other gadgets 

Thanks,
Dave

2100

LazyTurn / Re: LazyTurn

« on: July 28, 2008, 12:00:34 PM »

Not sure I completely understand what you're showing but it looks great!