Messages

1581

General Mach Discussion / Re: What's the correct hotkey?

« on: January 11, 2009, 08:03:06 PM »

Mine is listed as "Ctrl-Alt-J"

Hope that helps.

Dave

1582

Show"N"Tell ( Your Machines) / Re: Started my Taig enclosure......

« on: January 11, 2009, 12:04:04 PM »

That would be considered as Rich always says, that's "good junk" ! 

Dave

1583

Show"N"Tell ( What you have made with your CNC machine.) / Re: Routing Wood

« on: January 11, 2009, 11:08:35 AM »

Oh, I see, it's a laminate engraving type material. Gotcha, that makes complete sense now.

It looked like it was all leveled on the surface, hence the reason I thought it was inlaid 

Nice work-
Dave

1584

Show"N"Tell ( What you have made with your CNC machine.) / Re: Routing Wood

« on: January 11, 2009, 09:43:52 AM »

Teakie, how did you do the filling in the letters?

Dave

1585

Show"N"Tell ( What you have made with your CNC machine.) / Re: Routing Wood

« on: January 11, 2009, 09:40:34 AM »

Agreed, VCarve is an amazingly easy software but YOU put the design together and as simple as it may be, it's just beautiful and very very thoughtful as well - 

Dave

1586

Works in progress / Re: Another new screen

« on: January 10, 2009, 01:21:35 PM »

I don't even have a machine.

I wonder how many things you'll change after you really start digging into your machine. 

I've made so many changes to my screenset after I started doing certain things repeatedly and eliminating others that don't ever get used or at least moving them to another screen in the set that I "thought" were going to be used.

It looks really nice so far.

Dave

1587

General Mach Discussion / Re: FIX ICONS AND WHAT OPENS WHAT

« on: January 10, 2009, 08:27:00 AM »

Hi Chip,

A way that's a bit faster/easier is to just right click on the icon you'd like to open, and then click "chose program" and then a list of the programs will come up. Just highlight the one you want to open and then "check mark" the "always use this program to open this type of file" and it will associate that program from then on. Now if you just want to try that particular file  with that program, don't check the box and then nothing is permanent.

Dave

1588

Show"N"Tell ( Your Machines) / Re: Started my Taig enclosure......

« on: January 09, 2009, 10:54:46 PM »

That'd be great if I could figure out a way to keep it from spilling my mugs.....

Dave

1589

Show"N"Tell ( Your Machines) / Re: Started my Taig enclosure......

« on: January 09, 2009, 08:13:45 PM »

Rich, I would end up stepping on that damn thing and breaking my neck, I'm sure of it - 

Dave

1590

Show"N"Tell ( Your Machines) / Re: Started my Taig enclosure......

« on: January 09, 2009, 04:12:51 PM »

thanks, RC   

Dave