Messages

1181

Show"N"Tell ( Your Machines) / Re: New Project for the shop.

« on: August 29, 2009, 07:25:05 AM »

Very nice! Unfortunately I'm not that advanced - 

My work will have to be shown in pictures when it's done (and working  ).

Thanks,
Dave

1182

Show"N"Tell ( Your Machines) / Re: New Project for the shop.

« on: August 29, 2009, 07:10:24 AM »

Hey, you have to model those screws, not cheat.

Where'd you pick that up Gerry? 3D content central?


Tweakie, that's what I love about Mach 3, you can just reverse things if you're an idiot 

Dave

1183

Show"N"Tell ( Your Machines) / Re: New Project for the shop.

« on: August 28, 2009, 08:29:59 PM »

Thanks Ed and Russ,

SW 2005 and actually that thread is not too far off as they'll be 5 start threads. 

Dave

1184

Show"N"Tell ( Your Machines) / Re: New Project for the shop.

« on: August 28, 2009, 07:23:44 PM »

A few more shots for you with the table off.

Again, this is nowhere near done so please don't assume anything as I'm just playing around at this point  

1185

Promote and discuss your product / Re: New Wizards for Indexers

« on: August 28, 2009, 12:26:04 PM »

Email sent to the address above-

Dave

1186

Promote and discuss your product / Re: New Wizards for Indexers

« on: August 28, 2009, 09:50:23 AM »

When trying to download the manual:

Download Error!

This site has gone over its daily download limit

Please try again later

1187

General Mach Discussion / Re: New to Mach3- Problem with Corners

« on: August 28, 2009, 05:02:33 AM »

Hi Jim,

Have you checked your machine for backlash? If so, how much do you have?

Just the fact that it took more material going the opposite way would tell me something is "loose" in the axis drivetrain somewhere along the way.

Just a thought for you.
Dave

1188

General Mach Discussion / Re: Wierd Raggedy Pulsing.....

« on: August 26, 2009, 04:44:53 PM »

Ray, dumb question but is it possible it's the X and Y axis on the machine that's sticking since it's been sitting?

Dave

1189

General Mach Discussion / Re: File conversion

« on: August 26, 2009, 04:35:58 PM »

Agreed, that is definitely the best way for me to get a true accurate drawing of the subject.

VCarve is nice, but not THAT nice, lol!

Dave

1190

Show"N"Tell ( What you have made with your CNC machine.) / Re: Some early made XMas gifts

« on: August 26, 2009, 04:05:00 PM »

  Thank you sir -

Dave