Messages

51

General Mach Discussion / Re: Help!!!!!

« on: April 01, 2008, 11:41:31 PM »

I can edit the post for the Q if needed.

When I cut a circle I wont it to be smooth without the little flats,
so witch one do I leave unchecked?

52

General Mach Discussion / Re: Help!!!!!

« on: April 01, 2008, 10:59:43 PM »

Ok guys here's a screen shot of the VM post for spiral interpolation.
You can see the Q that it outputs.
If I select helical interpolation it will output a K

Should I delete the Q command or replace it with somting else?

Now for the helical interpolation is the K output ok or should I do somthing
with it?

53

General Mach Discussion / Re: Help!!!!!

« on: April 01, 2008, 09:28:38 PM »

Here ya go

54

General Mach Discussion / Re: Help!!!!!

« on: April 01, 2008, 09:20:28 PM »

Guys I don't know what I'd do with out !!!!

55

General Mach Discussion / Re: Help!!!!!

« on: April 01, 2008, 12:52:07 PM »

It's the X that's out.

I put a edge finder on the part to see if the X was still good
and found it to be out over an inch.

56

General Mach Discussion / Re: Help!!!!!

« on: April 01, 2008, 09:17:20 AM »

I don't think there's any G00's in the Hole pockting code.

57

General Mach Discussion / Re: Help!!!!!

« on: April 01, 2008, 09:03:46 AM »

Yes it is skipping steps.
After it cut what you see in the board I checked the X Y zero
and the X was way out, over an inch.

Chris

58

General Mach Discussion / Re: Help!!!!!

« on: March 31, 2008, 08:35:39 PM »

The hole is 1.0 why is the I-.25?

Chris

59

General Mach Discussion / Re: Help!!!!!

« on: March 30, 2008, 11:50:44 AM »

I cut a part about 6 mouths ago where it cut an arc and the arc was made up of lots of little flats.

I called the guys at VM and they told my where to make changes so VM would cut the arcs smooth with out the segments.

With this selection made VM outputs the I&J’s for hole pocketing.

60

General Mach Discussion / Re: Help!!!!!

« on: March 30, 2008, 10:40:42 AM »

Visual mill 5.0