Messages

21

General Mach Discussion / Re: How do I activate "allow block delete"

« on: May 04, 2006, 01:58:03 PM »

How easy can it be. How could I have overlooked something so obvious. I've yet to check my machine though. No doubt the switch will be there.

Thanks,

22

General Mach Discussion / How do I activate "allow block delete"

« on: May 03, 2006, 06:52:13 PM »

Where's the switch to activate "allow block delete"

Thanks

Jim

23

General Mach Discussion / Re: What's the best way to determine motor velocity?

« on: May 03, 2006, 05:38:38 PM »

In my case its the rapid that takes it over the top. Wouldn't it be nice if the FRO only affected feed rates below the max. For example, I decide because of a light cut I can up the rate so I F11 the FRO. Now in a rapid my z is skipping steps. I hate that.

Jim 

24

General Mach Discussion / how do I block delete

« on: May 03, 2006, 02:36:16 PM »

Using Mach II my posts place a double forward slash in front of remarks. Mach II does not read blocks, lines, prefaced with double forward slashes. On the other hand, Mach III errors on double forward slashes and stops processing the program. It was suggested I need to activate "enable block delete". Seems simple enough but through all the searching I've done I can't find a switch to enable block delete. How about it, does it exist and where do I find it.

jim