Messages

11

General Mach Discussion / Re: Finding the middle of a circle.

« on: May 29, 2007, 02:43:01 AM »

Ok due the lack of sleep and being alittle bit rushed I clicked on the wrong wizard.  I have now found the wizard you are talking about.  And it looks exactly like you showed it to be.  Thanks for the help.  I am going to go try it and then prolly go to bed !  Once again thanks for the help.

12

General Mach Discussion / Re: Finding the middle of a circle.

« on: May 29, 2007, 02:28:41 AM »

When I go to that wizard hood it looks nothing like that.  Any suggestions?  Maybe you have a higher verison than I do.  I will look around and see if can DL a high verison of this wizard.

13

General Mach Discussion / Re: Finding the middle of a circle.

« on: May 29, 2007, 01:54:33 AM »

I do not plan on using a probe.  I plan on using a Edge Finder.  I dont think this will work with a Edge Finder.

14

General Mach Discussion / Re: Finding the middle of a circle.

« on: May 28, 2007, 10:41:37 PM »

I Dled the file.  But what do I do with the file?  I clicked on it and it said Wizard Installed.  But when I try and use it in mach3 it says file missing.  I might be doing something wrong.

15

General Mach Discussion / Re: Finding the middle of a circle.

« on: May 28, 2007, 07:50:11 PM »

are you talking about a wizard in new fangled solutions? or some other type of wizard?

16

General Mach Discussion / Finding the middle of a circle.

« on: May 28, 2007, 06:05:12 PM »

I have these 1" Dia. X 1" Long Plastic Peiced I mill a oval threw.  But the Oval has to be in the middle.  I think there is something in the offset page about finding the middle of a circle but I dont understand how it works.  So if someone can please show me how it works.  Pretty much all I want to do is use my electric edge finder to locate the middle of a round bar.

Thanks Eric,

17

General Mach Discussion / Re: Ignore tool change setting

« on: March 28, 2007, 12:42:38 PM »

It seems to be working now.  I guess when I change a setting I should click normal conditions and then restart mach3.

18

General Mach Discussion / Re: Ignore tool change setting

« on: March 28, 2007, 11:38:52 AM »

I am running verision 2.0

19

General Mach Discussion / Re: Ignore tool change setting

« on: March 28, 2007, 11:24:59 AM »

Im talking about starting my comp up and opening mach3.  Seems like evertime I exit mach3 and reload it i gotta redisable ignore tool change.

20

General Mach Discussion / Ignore tool change setting

« on: March 28, 2007, 10:24:34 AM »

Why will my ignore tool change setting not stay disabled?  ever time i load mach3 I half to disable it.  Afew times I have forgotten and it got lucky and stoped it b4 it used the wrong tool.