Messages

31

Mach3 under Vista / Re: Getting up and running in Vista

« on: October 14, 2007, 10:41:43 AM »

found out that it does not work with vista 64

32

Mach3 under Vista / Re: Getting up and running in Vista

« on: October 11, 2007, 02:12:56 AM »

I am also trying to run mach through a virtual parallel port as my motherboard does not have one on the machine.

33

Mach3 under Vista / Re: Getting up and running in Vista

« on: October 10, 2007, 02:07:55 PM »

no luck at all with vista 64

I have followed the install procedure a the start of this post.

Install 2.49
Modify reg
Checked driver. Nothing

No Driver sensed installed. Run Driver Test.

I hit OK run again and the same message appears.

At no point did the software ask me to reboot but i re booted after each stage.

I was planning not to use this pc for my cnc machine but the old machine has an un usable IDE controller problem which is allway causing disk corruptions and it is pot luck if it works and then may require reinstalling.