61
General Mach Discussion / Found this driver
« on: January 18, 2006, 10:01:37 PM »
Hello,
Im not too proficient with the driver lingo, I currently use Geckos, and im building a second machine. I found this driver its supposed to be AC powered and 7.8 Amps, and microstep selectable to at most 50 microsteps per step.
Would these drivers work with mach 2/3?
Would these drivers eliminate the use of a dc power supply?
Ill attach the pdf spec sheet.
Regards
Fernando
Im not too proficient with the driver lingo, I currently use Geckos, and im building a second machine. I found this driver its supposed to be AC powered and 7.8 Amps, and microstep selectable to at most 50 microsteps per step.
Would these drivers work with mach 2/3?
Would these drivers eliminate the use of a dc power supply?
Ill attach the pdf spec sheet.
Regards
Fernando