Hello Guest it is March 29, 2024, 03:38:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - garyn

Pages: 1 2 »
1
General Mach Discussion / Re: multiple depth cuts
« on: June 02, 2022, 11:40:20 AM »
Sorry about that

2
General Mach Discussion / Re: multiple depth cuts
« on: June 02, 2022, 11:33:27 AM »
I am using Carbide Create and Carbide Motion.

3
General Mach Discussion / multiple depth cuts
« on: June 02, 2022, 10:57:03 AM »
what do I need to do to make the Shapeoko cut multiple depths?  I want to cut 3/4" plywood with 1/4" bit in 2 passes.  I have tried saying the bit will only cut 3/8" at a  time, but the tool path shows cutting the plywood in one pass.  What do I need to change?

4
General Mach Discussion / Re: Bit depth zeroing tool help
« on: May 27, 2022, 09:05:33 AM »
I got the latest version of Mach 3 installed, and the used the "TPS'S" version of the auto tool zero script, and it all works.  Since I usually z zero somewhere on the material, I would like for that script to send the z axis back to X0Y0.  I have pm'ed "TPS" asking for his assistance.

Thanks again for your assistance.
Gary

5
General Mach Discussion / Re: Bit depth zeroing tool help
« on: May 26, 2022, 10:23:13 AM »
Should I also save the auto tool zero script as a .mcc file?

6
General Mach Discussion / Re: Bit depth zeroing tool help
« on: May 26, 2022, 09:55:29 AM »
Will XP run the latest Mach 3 version?

7
General Mach Discussion / Re: Bit depth zeroing tool help
« on: May 25, 2022, 08:28:55 AM »
Don't lnow at this point if that will work, but I want to thank you for your patience and persistence.  I know I don't have the latest version of  Mach 3, so I will get that downloaded and installed.  Then I will try single stepping the script and see what happens. I will let you know what happens.

8
General Mach Discussion / Re: Bit depth zeroing tool help
« on: May 24, 2022, 08:03:21 PM »
How do you single step through the code?

9
General Mach Discussion / Re: Bit depth zeroing tool help
« on: May 24, 2022, 04:24:54 PM »
That one didn't work--got same error message.

10
General Mach Discussion / Re: Bit depth zeroing tool help
« on: May 24, 2022, 02:41:46 PM »
What do you suggest? Anyone in particular that I could contact that might have the solution?

Pages: 1 2 »