Hello Guest it is March 28, 2024, 01:52:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Stevenjoe

Pages: 1
1
Hello, I am in the process of setting up a 3017t from china of course it uses a rnr motion breakout board. I have it running gcode but seem to be having problems with cutter comp or I just dont have mach 3 set up correctly to cut to size. Also what has turned into more hours than I would like to admit to without any success is to get a china usb MPG to do anything other than the leds to blink when it has power. The pulse led does blink when you turn the dial. I have tried to only macropump program I could find online but it acutally make the software mpg with mach 3 not function properly the step can not be changed when it is running. Is there code available to make the function? Any help would be greatly appreciated thank you in advance for any advice.
Steve

Pages: 1