Messages

11

General Mach Discussion / Re: ports/pin setup problems

« on: October 11, 2007, 10:02:15 AM »

what could cause the z to work right and x y a to be confused with the same setup as mach 2 ?

12

General Mach Discussion / Re: ports/pin setup problems

« on: October 10, 2007, 05:11:58 PM »

are the port/pin setup the same
mach 2 runs well mach 3 has confused signals to the x+y motors

13

General Mach Discussion / ports/pin setup problems

« on: October 09, 2007, 01:44:17 PM »

when i try to set up mach3 with the same parameters as mach2 it wont run my cutting table the same can i copy and paste settings?

14

General Mach Discussion / Re: plasma thc on the fly

« on: October 09, 2007, 09:46:55 AM »

 :)i worked on it this weekend and have it working fine on my laptop with a new screen i modified if all goes well on the machine i am willing to post my screen
thanks to everyone for the help glad we can figure stuff out together

15

General Mach Discussion / Re: plasma thc on the fly

« on: October 05, 2007, 05:20:39 PM »

i now have the controls working but i would like a finner control but the step mode doesnt work can anyone figure that out?

16

General Mach Discussion / Re: R2.0.031 and plasma.set

« on: October 05, 2007, 05:11:20 PM »

can i change the feed overide section of the plasma screen in mach3 to function like the mach2 screen
i prefer buttons and hotkeys to the slide or can i just add hotkeys to the slide?

17

General Mach Discussion / Re: Jogging Z axis while machine is cutting

« on: October 05, 2007, 04:25:15 PM »

i have tried it with no sucsess what version are you using? what hot keys
do you use the jog function?
any help would be great

18

General Mach Discussion / plasma thc on the fly

« on: October 04, 2007, 06:49:51 PM »

i am using mach2 and want to setup mach3 to adjust thc in step mode while running a program  can it be done and what are the oem codes
what is the best way to modify a screen for feed overide with buttons and hotkeys like mach2 rather than the slide in mach3
i tried screen 4 with no luck when i load a screen to modify the dro for x y z are moving
 thanks for any help to get me started in the right direction