Hello Guest it is May 14, 2021, 12:36:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dja

Pages: 1
1
General Mach Discussion / torch turns on before g01 down move no dwell
« on: October 02, 2008, 03:10:38 PM »
 i can't find a way to edit the code generated in bobcad to do a g01 z 0.0000 move. dwell and then m03 and start cut
the torch turns on @ z1.0000 dwells & moves to z0.0000

2
General Mach Discussion / cutting aluminium with plasma
« on: November 02, 2007, 05:32:59 PM »
i am wondering if anyone has figured out the best settings for a clean cut in aluminium with a plasma
i am getting a feathered finish and dont like having to clean the parts
let me know what works best
i am using a hypetherm 1650

3
General Mach Discussion / motor noise
« on: November 02, 2007, 03:16:03 PM »
after a lot of trial and error i have the motors turing properly on my plasma table with mach3 but my rapid speed is much slower than it was in mach 2  when i try turning it up it make a loud crunching sound is there some tricks to tuning i have missed i have tried enhanced pulsing pulse width accel and velosity settings but cant get the same smooth motion i had with mach 2 the only thing working properly is the step motion 10 " is 10"

4
General Mach Discussion / ports/pin setup problems
« on: October 09, 2007, 01:44:17 PM »
when i try to set up mach3 with the same parameters as mach2 it wont run my cutting table the same can i copy and paste settings?

5
General Mach Discussion / plasma thc on the fly
« on: October 04, 2007, 06:49:51 PM »
i am using mach2 and want to setup mach3 to adjust thc in step mode while running a program  can it be done and what are the oem codes
what is the best way to modify a screen for feed overide with buttons and hotkeys like mach2 rather than the slide in mach3
i tried screen 4 with no luck when i load a screen to modify the dro for x y z are moving
 thanks for any help to get me started in the right direction

Pages: 1