Hello Guest it is September 30, 2023, 09:36:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Noahnett

Pages: 1
PoKeys / Re: PoKeys57CNC, support for g31.1,g31.2,g31.3
« on: July 05, 2023, 01:47:48 PM »
The issue still exists in 2023. It's a little frustrating when [url https://blog.poscope.com/cnc-tool-setter-with-pokeys-and-mach4/]they'll post an article on how to set up a toolsetter[/url], and you go through all of the instructions, only to realize I can't use my original probe as well as a toolsetter.

PoKeys / Re: Porelay8 with Mach 4 and Pokeys57CNC relays not triggering
« on: August 10, 2022, 12:48:47 PM »
Hey Splint,

I don't have a clear answer, but I have been troubleshooting a similar issue. Did you leave the PoExtension cable connecting the Pokeys57 and PoStep-XX drivers (assuming you're using PoStep drivers) after your initial configuration? This cable can be left on after initial config, but should be removed after (unless you're wanting to monitor the drivers using Mach4, then you'd still need to disconnect pin 1 from that series). My setup with the PoRelay8 started working again after I removed that flat cable. Hopefully this helps!


Pages: 1