Messages

21

General Mach Discussion / Re: want some simple circuit to test mach3 with a small step motor?

« on: May 05, 2006, 10:51:49 PM »

any small pre-build board that mach3 can use and talk thru it? any link?
thanks

22

General Mach Discussion / want some simple circuit to test mach3 with a small step motor?

« on: May 04, 2006, 10:12:04 PM »

I just buy one step motor: oriental motor PK244-02BA with 6 wire DC
0.8A 7.5ohm 2 phase and a ic MC3479P stepped motor driver,
would like to know is there some simple circuit I can build and test
the step motor from the pc?
this 2 items cost me $12 but I think is the good start to learn
something new.
thanks

23

General Mach Discussion / looking for tangential cutter and chasing tool

« on: April 25, 2006, 10:27:54 PM »

I am in the process to design a router table for cutting corrugated card board, and try to find supplier for tangentail cutter and chasing tool for box making, if anyone know of any link to this type of tool head, please let me know.
I do know mach3 & 4 has build in function for this already.
Thanks.