Hello Guest it is March 28, 2024, 11:54:19 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Biotech1

Pages: 1
1
General Mach Discussion / Calibration???
« on: April 13, 2008, 05:07:38 PM »
Puzzled  ??? i made 2 1 inch squares and 2 1 inch circles I pocketed 1 square and one circle  it came out at .9998  and when i do the profile outside its bigger than 1 inch and I'm using a .125endmill with vcarve pro.... any suggestions as to why its perfect one one and real crappy on the other...

2
General Mach Discussion / The new Upgrade doesn't like Arcs.
« on: December 23, 2007, 01:21:59 PM »
Boy what a mistake.  I upgraded to the newest mach release and now The problems begin.  It doesn't like mach2/3 Arc (inch).txt .  It loads with a hole bunch of circles on my g-code> but when i just select mach 2/3 (inch).txt the g-code loads normal.. any help on whats going on would help me out allot... ??? >:(

Pages: 1