Hello Guest it is January 25, 2022, 12:22:42 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jluisrey

Pages: « 1 2
12
Third party software and hardware support forums. / Mach3 and gecko G340
« on: February 27, 2007, 09:44:57 AM »

Hello, i'm configuring mach3 with gecko's 340 drives, it has an usefull alert signal, on an input/output pin, that helps to emergency stop on error, but when this condition ocur the drive needs this pin to put high for 5 secons, can be this configuration done on mach3 to "reset" the geckos from the program.


Regards
Rey

Pages: « 1 2