Hello Guest it is March 28, 2024, 11:10:42 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jluisrey

Pages: 1 2 »
2
Mach SDK plugin questions and answers. / How to start with SDK
« on: December 28, 2010, 10:12:41 AM »
Hello, I want to make a small plugin for Mach3, I've experience developing in c++, (Is my job),

Where may I download the Sdk and some samples?? Or find a "Starter page",

Thanks for all,

Regards
Rey

3
Hello,

Here you have the excell sheet and the program to generate the gcode, I will try to do a Mach3 wizard, but I don't know were to start ;O)

http://www.saand.es/joseyana/temp/gcode_helgears.zip

Regards
Rey

4
General Mach Discussion / Re: Using Mach3 as Lathe Dro
« on: April 01, 2008, 10:37:56 AM »
With parallel port pins will you recomend to connect the encoders and the index??

Regards
Rey

5
Hello Glenn,

3 Axis are used, X,Z,A, and the deep was 3mm, one pass cut (the material is PVC),

I write a small program and a excel sheet to generate gcode for gear, need tool angle, number of toochs, space bettwen tooch, and desired angle,

Regards,
Rey

6
A sample of helical gear cut on PVC with Mach3:



Regards,

7
General Mach Discussion / Re: Using Mach3 as Lathe Dro
« on: March 31, 2008, 06:40:55 AM »
Other question more... Can mach3 read the encoder in quadrature mode (4x res) ??

Regards,
Rey

8
General Mach Discussion / Re: Using Mach3 as Lathe Dro
« on: March 31, 2008, 05:04:17 AM »
Hi, thanks with the info, I will try to customize a screen, on the Dro window you can't change current cooridnates, just 0,

Other question its how to configure the index pulse to view RPM's on the sprindle?

Regards,
Rey

9
General Mach Discussion / Using Mach3 as Lathe Dro
« on: March 28, 2008, 08:23:19 AM »
Hello Friends, I'm planing to use the mach3 as Lathe DRO, I've seen the screen, but I didn't see how to do some basic things:

In the dro screen, it is posible to change the coordinates manualy?
It is posible to set the focus field with the keyboard? (just to use a numeric keypad near de lathe, and use it to set x,y position without a mouse)

Regards,
Rey

Pages: 1 2 »