Messages

11

HiCON Motion Controller / Re: Couple questions about ArcPro

« on: December 15, 2021, 06:48:57 PM »

Thank you both for the replies! This is very helpful.

Yes, HVLB was a typo. I meant HLFB.

12

HiCON Motion Controller / Couple questions about ArcPro

« on: December 12, 2021, 05:23:38 PM »

I'm debating between the ArcPro and ESS/TMC3in1. I have a few questions about the ArcPro:

1. With the TMC3in1, Mach4 will load THC settings from the gcode. It seems with ArcPro you have to select your material/THC settings in Mach4? Can ArcPro load THC from gcode instead?

2. ESS has it's own post processor and settings for Sheetcam. I have not been able to find a post processor for the ArcPro, is there one and I'm just not finding it?

3. I plan to use OHMIC torch sensing. Do I need an adapter or anything to use OHMIC with the ArcPro?

4. I will be using Clearpath motors. Do the wire directly to the motion controller for step/dir and HVLB?