Messages

81

General Mach Discussion / Re: Mach3Turn

« on: September 28, 2007, 11:55:37 AM »

Arnie

Downloaded extra wizards followed were to put them, but now have lost Turn screen. Done Veiw/Load screens/turn addons, but no joy
were am I going wrong.

Thanks

Mike

82

General Mach Discussion / Re: Mach3Turn

« on: September 28, 2007, 05:19:34 AM »

Arnie

Can't find your wizards in download section!! could you point the way

Thanks

Mike

83

General Mach Discussion / Re: Mach3Turn

« on: September 27, 2007, 11:23:28 AM »

Arnie
Ok got it, I had made a mistake on x end number which ironicly was the same as clearance value, hench much confusion.

As I have an awefull memory I will write a set of instuctions, and will post for others, would you check them?

Thanks for your help

Mike

84

General Mach Discussion / Re: Mach3Turn

« on: September 26, 2007, 05:46:34 AM »

Arnie

Thanks for reply, doing test turns, I have found you have to minus the clearance value from the X end value, as tool goes to +X clearance at start of cut run, is that your experiance? or am I not running programme as intended.
It would be helpfull if we had a video tutorial for turn wizards! maybe the guys are working on one.

Mike

85

General Mach Discussion / Mach3Turn

« on: September 24, 2007, 01:57:05 PM »

Hi
I am new user of Mach3Turn, on turn wizards O/D turning, could someone explain the clearance values.

Thanks

Mikemill