1

**General Mach Discussion / Re: Tangential Knife Setup**

« **on:**December 10, 2009, 02:46:44 PM »

thank you for the info, this is a simple gcode of a triangle, no G0 commands in the drawing triangle; the rotation of my A axis is working OK but not lift at vertex.

----------------------------------------------

%

G90

G71

G40

S15000

T1

G0 X0.000 Y0.000 F1000.000

Z-10.000

G0 X30.000 Y-58.875 Z-10.000

G1 Z0.500 F600.000

G1 X47.250 Y-18.375 F800.000

X72.750 Y-58.875

X30.000

G0 Z-10.000

G0 X0.000 Y0.000

G0 Z-10.000

G0 X0 Y0

M30

M2

%

--------------------------------------------------------

The A axis change to 66.1 then 302.4 then 180 degrees it is ok but the Z axis not change to 1 at vertex.

The parameters in xml is lift angle+45 and lift z 1, I tried to change this but nothing happens .

What am I doing wrong?

----------------------------------------------

%

G90

G71

G40

S15000

T1

G0 X0.000 Y0.000 F1000.000

Z-10.000

G0 X30.000 Y-58.875 Z-10.000

G1 Z0.500 F600.000

G1 X47.250 Y-18.375 F800.000

X72.750 Y-58.875

X30.000

G0 Z-10.000

G0 X0.000 Y0.000

G0 Z-10.000

G0 X0 Y0

M30

M2

%

--------------------------------------------------------

The A axis change to 66.1 then 302.4 then 180 degrees it is ok but the Z axis not change to 1 at vertex.

The parameters in xml is lift angle+45 and lift z 1, I tried to change this but nothing happens .

What am I doing wrong?