Hello Guest it is March 28, 2024, 09:37:16 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - johnmb1946

Pages: 1 2 »
1
SmoothStepper USB / Re: smoothstepper and x axis
« on: November 28, 2012, 07:19:42 AM »
Hi Jeff & Hood

Found the Problem  I Purchased two cables when I bought the smoothstepper
 the one connected to port 1 is faulty found out when I swapped them over.
all Axis are now working thanks Guys for your help much appreciated.

thanks again John

2
SmoothStepper USB / Re: smoothstepper and x axis
« on: November 28, 2012, 07:02:17 AM »
Hi Jeff
do you mean the short cables that go from the pmdx board to the smoothstepper

john

3
SmoothStepper USB / Re: smoothstepper and x axis
« on: November 26, 2012, 10:35:33 AM »
Hi Hood
changed pin outs for x and y axis so what should be y axis is moving as x axis now
 but x axis which is now the y axis is not moving but shows as moving in Dro.

4
SmoothStepper USB / Re: smoothstepper and x axis
« on: November 26, 2012, 03:49:38 AM »
Hi Hood
Yes the dro moves when using Mdi in put.
John

5
SmoothStepper USB / Re: smoothstepper and x axis
« on: November 25, 2012, 06:21:33 AM »
Thanks Hood
Here's my XML file

6
SmoothStepper USB / smoothstepper and x axis
« on: November 24, 2012, 11:04:28 AM »
I have finally got  round to installing my Usb smooth stepper which I have had for a few years now
I Have  PMDX 126 Board and a PMDX 107 Im running mach 3 .034.066 using machstdmill  screen set
The problem that I have is that everything works  great except that my X axis will not move at all
it works perfectly with the Parallel port but not with the smooth stepper.
Any help would be much appreciated as Im  getting very dispondant with this,

John

7
CVI MachStdMill (MSM) / Re: setting up tcp tp
« on: November 09, 2012, 06:04:04 AM »
Hi Dave
I checked settings,altered them  for max z travel but now getting
PROBE FAST FEED <=0, OP CANCELLED

8
CVI MachStdMill (MSM) / setting up tcp tp
« on: November 08, 2012, 01:46:37 PM »
help needed tried setting up tcp tp have set plate position
when i press set TCP TP MCz all i get is  error saying
MAX Z DIST <=MIN PROBE DISTANCE, OP CANCELLED
any help would be much appeciated

9
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: June 13, 2012, 05:12:23 AM »
Hi Gerry

Sorted thanks machine now sorted after a year of alterations just got a 4th axis to do now.

John

10
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: June 12, 2012, 02:45:15 PM »
i Gerry
here's the xml and a file i have been cutting
thanks
john

Pages: 1 2 »