1
General Mach Discussion / Won’t finish homing
« on: January 31, 2021, 07:38:08 PM »
I recently replaced my stepper drivers and recalibrated everything but now when I home mach3 seems to get stuck. I use limit switches and select reference all home. The machine moves to the limit switches and activates them then backs off to deactivate them and it does this for all 3. Z first then y then x. At this point it still says “homing” in the bottom bar on the screen. I can hit reset which stops it and then proceed to run my program and there are no issues during the cut. Any ideas why it doesn’t complete the homing process? Before I installed the new stepper drivers I had no issues.