1
General Mach Discussion / Re: Won’t finish homing
« on: February 06, 2021, 06:15:20 PM »
When I set up my machine I was never able to get the 4th motor running on its own axis. At that time I wired both y axis motors to the y driver. When I replaced the drivers I tried again and in doing so turned on the slave function in mach3. When I was homing I believe it was trying to home the slave axis as I did not go back into the settings and turn it off. I turned it off today and the problem is solved.
Thanks to those that responded.
Thanks to those that responded.