Hi Guys,
I am having an issue with a fixed tool setter and the m6 macro.
I'm no expert at Lua - and thats being generous!
I have tried a few different scripts to allow a manual tool change followed by a tool height probe to a fixed tool setter. I tried DazTheGaz's script but my machine just froze and didnt move. I found the script for the m6 toolchange on the mach4 basics video (
https://www.youtube.com/watch?v=6-4JkDv9AgM) and all seemed good but a bit clunky. The machine did its thing, then measured the tool all good. The problem comes it does not set the WCS zero correctly so is basically useless.... not sure what is going on or if im missing something in the tool change/offsets !!
Any advice is very welcome!!
TIA Tim