Hello Guest it is January 27, 2022, 03:57:18 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - waterfx

Pages: 1
General Mach Discussion / A axis stepper rotation error
« on: January 19, 2021, 02:41:48 PM »
Trying to use a axis for rotary scan.  I aligned X, Y axis to center of plate.  My A axis stepper is over rotating for a 360 degree program.  One full rotation of plate registers as ~300 degrees in controller.  The belts and gears are not slipping and there doesn't seem to be any tangible fault.

Pages: 1