Hello Guest it is March 29, 2024, 05:59:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marcel beaudry

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »
31
General Mach Discussion / spindle rotation are reversed
« on: September 29, 2009, 11:46:46 AM »
Hello to all

My spindle is reversed when i input m03 it goes anticlockwise and m04 it turns clockwise.

How do i resolve this problem

Thank you for your time

Marcel

32
 Very nice

Marcell Beaudry

33
General Mach Discussion / Re: 4 axis
« on: July 20, 2009, 04:04:33 PM »
THANK YOU again Chip


Marcel

34
General Mach Discussion / Re: 4 axis
« on: July 20, 2009, 03:47:50 PM »
Hy Chip

So if i want to make 2 turns i just type the total amount of degres needed like 720

35
General Mach Discussion / 4 axis
« on: July 20, 2009, 03:25:35 PM »
Hello

I understand that when i want to make one rotation of the fourth axis the g code will be g1 A360 f.002 .But what if i want to make more than one rotation of the A axis.

Thank you for your time

Marcel Beaudry

36
General Mach Discussion / Re: Orac Lives
« on: July 13, 2009, 02:06:45 PM »
Hello Derek

Got one just like yours it is a very good lathe

Marcel

37
General Mach Discussion / Re: Total NOOB Quick start guide. ?
« on: July 13, 2009, 02:03:04 PM »
Hello

Have you made one

Marcel

38
Hello Aaron

You have done everything by the book, the only thing left is a more powerful milling.

Nice video

Marcel beaudry

39
Good design fancy works very well done


Marcel Beaudry

40
Hello Tweaky

Thank you for the info

Marcel

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »