Hello Guest it is April 25, 2024, 08:13:07 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marcel beaudry

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »
21
Show"N"Tell ( What you have made with your CNC machine.) / Re: MODEL 629 S&W MAGNUM
« on: December 19, 2009, 10:02:26 PM »
Rich

I read of some person who use a reamer rounded the edges of cutting surface plunged it into the bore of the barrel and the result was the illusion that the bore was rifled

Marcel

22
Show"N"Tell ( What you have made with your CNC machine.) / Re: MODEL 629 S&W MAGNUM
« on: December 19, 2009, 05:42:40 PM »
Rich
try this

http://www.firearmsid.com/A_bulletIDrifling.htm

http://bbs.homeshopmachinist.net/showthread.php?t=32026

http://www.airgundevelopment.com/rifling.html

http://www.huidesign.com/miniature/index.php?option=com_content&view=article&id=5&Itemid=15&lang=en

23
Show"N"Tell ( What you have made with your CNC machine.) / Re: MODEL 629 S&W MAGNUM
« on: December 19, 2009, 11:23:37 AM »
Hello Rich

The button turns by itself ,it is like driving a spiral nail in wood .
there are sites on the internet that shows how to make miniature firearms

Marcel Beaudry

24
Show"N"Tell ( What you have made with your CNC machine.) / Re: MODEL 629 S&W MAGNUM
« on: December 18, 2009, 08:59:20 PM »
Hello Rich

No the button as the same helix angle as your original barrel ,if you can have access to a press you can push the button trough the bore and it automaticaly creates the spiral.

Google rifling button

Marcel Beaudry

25
Show"N"Tell ( What you have made with your CNC machine.) / Re: MODEL 629 S&W MAGNUM
« on: December 18, 2009, 01:53:40 PM »
Hello Rich

look for button rifling

it might give you another option

Marcel Beaudry

26
Share Your GCode / Re: Square & Compass
« on: December 18, 2009, 01:05:52 PM »
Hello

Try this

Marcel

P.S for those who want to find logos go to

/www.logotypes.ru/default_e.asp

27
Show"N"Tell ( What you have made with your CNC machine.) / Re: My Clock
« on: November 10, 2009, 10:24:01 AM »
Hello Art

Real nice clock

Marcel Beaudry

28
General Mach Discussion / Re: spindle rotation are reversed
« on: September 29, 2009, 02:08:38 PM »
Hello Hood

Problem resolved

Thank you for the advice and your time

Marcel

29
General Mach Discussion / Re: spindle rotation are reversed
« on: September 29, 2009, 01:57:55 PM »
Hello Hood

How do i do that

Marcel

30
General Mach Discussion / Re: spindle rotation are reversed
« on: September 29, 2009, 12:16:00 PM »
Hello Hood

i think it goes via the output on the spindle setup page

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »