Messages

151

Works in progress / Re: An unfinished screen set - "Mach Blue"

« on: April 19, 2006, 05:23:15 PM »

hello to all

is there a functionnal mach3 screen for lathe that i can use the color that i saw where just eye catcher fantastic work

marcel beaudry

152

General Mach Discussion / Re: mach2 and G76

« on: April 19, 2006, 05:05:18 PM »

dear sir

i can see the light at the end of the tunnel both the axes work as they should in manual and in program mode the only thing missing is the spindle turning even when i input a speed by hand the spindle does not turn thank you for your time

marcel beaudry

153

General Mach Discussion / Re: mach2 and G76

« on: April 18, 2006, 08:19:20 PM »

i will try tomorrow and thank you again

marcel beaudry

154

General Mach Discussion / Re: mach2 and G76

« on: April 18, 2006, 05:34:40 PM »

Dear Sir
thank you very much for spending your time for me . i installed mach 3 and put the xml file you sent me when i ran the jog mode in z mode - the lathe went in x -  and when i tied z+ it went in x+ and the spindle did not turn.for the x axes they did not work.  when i tried the ball program included in mach 3 the spindle did not turn and the z axes where reversed and the x axes where ok . and thank you again for your time 

marcel beaudry

155

General Mach Discussion / Re: mach2 and G76

« on: April 17, 2006, 10:17:09 AM »

is this the xml file you needed

156

General Mach Discussion / Re: mach2 and G76

« on: April 16, 2006, 10:19:18 PM »

you got an email i hope this is the file you need

marcel

157

General Mach Discussion / Re: mach2 and G76

« on: April 16, 2006, 09:40:54 PM »

dear sir
i got mach2 registered and it works very well with my lathe i am not sure how to transfer to mach3 . the lathe was sold to me with the software .i bought the license from art and i am not sure how to transfer all the info and have a lathe that still work

158

General Mach Discussion / mach2 and G76

« on: April 16, 2006, 07:56:17 PM »

is there a way to use G76 to make threads with mach 2 i wish to make 5/8 11 threads and i program my part by hand thank you for your time Marcel Beaudry