Hello Guest it is March 29, 2024, 09:13:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marcel beaudry

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »
141
General Mach Discussion / Re: square threads
« on: May 12, 2006, 09:34:26 PM »
Dear sir

thank you for your quick reply what is the difference in external threads and internal execution wise

Marcel

142
General Mach Discussion / Re: square threads
« on: May 12, 2006, 09:14:42 PM »
thanks you

Marcel

143
General Mach Discussion / Re: Mach2 works fine but...
« on: May 12, 2006, 09:02:38 PM »
i had the same problems with my lathe mr Barker helped me but could not get the spindle to turn then the maker of my lathe came to my home and tried a combination of input and output changes and got my lathe started with all feeds and spindle running like in mach2 (thanks again steeve) .if you wish i can send you the xml file for you lathe .

144
General Mach Discussion / square threads
« on: May 12, 2006, 08:51:47 PM »
how do you program the thread wizzard to make square threads

145
finally a lathe screen . very well made, eye popping ,when it's fully tested i would like it to be my screen . you realy know how to make screens . fantastic work bravo to the team .

146
General Mach Discussion / tutorial for threading simple and complex
« on: May 10, 2006, 10:13:36 AM »
would it be possible to have a tutorial on complex threading . what all the information boxes are for .thank you

147
General Mach Discussion / Re: mach2 and G76
« on: April 22, 2006, 11:11:35 AM »
Dear Sir

i am willing to try anyting to make the lathe work . the last file worked on both axes but the spindle still will not turn and when i go to diagnostic now it is output 3 that flashes red

thank you for your time

marcel beaudry

148
General Mach Discussion / Re: mach2 and G76
« on: April 21, 2006, 03:40:27 PM »
Dear Sir

i d'ont know if it has a bearing on my spindle not turning but when i go to diagnostic i have (output 2 flashing)

marcel beaudry

149
Works in progress / Re: An unfinished screen set - "Mach Blue"
« on: April 20, 2006, 03:23:06 PM »
thank you i will wait

150
General Mach Discussion / Re: mach2 and G76
« on: April 19, 2006, 09:42:27 PM »
dear sir

is there some things i can check in the configuration

marcel beaudry

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »