Hello Guest it is March 28, 2024, 07:21:10 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marcel beaudry

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »
131
General Mach Discussion / Re: shift key
« on: June 03, 2006, 02:44:33 PM »
thank you

you solved part of my problem and i found the other part if you tap your key 5 times in a row window's  , window's removes the association with other keys like the control key alt key and the shift key you must press shift key 5 more times to receive the window's box and you have to tell it you want to restore the association to the keys mentionned in the above
thank you again

marcel

132
General Mach Discussion / shift key
« on: June 03, 2006, 02:06:03 PM »
is it possible to lose the use of the shift key in mach3  when i use the arrows keys it feeds ok when i try to use shift + the arrows the lathe does not move any faster thank you in advance

marcel

133
General Mach Discussion / Re: fast feed
« on: May 21, 2006, 10:09:28 AM »
thank you i will try it today

marcel

134
General Mach Discussion / Re: fast feed
« on: May 20, 2006, 11:35:40 PM »
yes  the slow jog will go faster at 100% . but when i used the fast jog it went faster than the slow jog and i could use the slow jog to machine at the same time use the fast jog(shift + jog ) to move the tool out of the cut faster than the slow jog

135
General Mach Discussion / Re: fast feed
« on: May 20, 2006, 11:24:22 PM »
my screen does not look like that it looks like, if you look at general discussion and mach3 screen (where they make new screens for mach3 ) and look at the diagnostic sceen you will find what my screen looks like . (sorry for the delay my neibourg invited me for dinner)   



Marcel

136
General Mach Discussion / Re: fast feed
« on: May 20, 2006, 05:35:45 PM »
dear sir
all i got on the left side are 4 encoders 3 mpgs  below is the threads diagnostics  below that x dro z dro

137
General Mach Discussion / Re: fast feed
« on: May 20, 2006, 04:46:45 PM »
Dear sir 
are you using mach 3 turn  in diagnostic i cannot find (fast jog rate)

thank you
Marcel

138
General Mach Discussion / fast feed
« on: May 20, 2006, 02:55:12 PM »
lost my fast feed in mach 3 is there a way to get it back thank you for your time Marcel Beaudry

139
General Mach Discussion / Re: square threads
« on: May 13, 2006, 02:08:11 PM »
thank you Mr Barker  worked like a charm 

140
General Mach Discussion / Re: square threads
« on: May 12, 2006, 09:52:16 PM »
yes this is what i wanted i will try it tomorrow (wife in bed lathe in the basement under the bedroom if you want me to give you a reply from the same adress , ill try it tomorrow)

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 »