105
« on: January 09, 2007, 12:52:44 PM »
Hello Brett
to make the tool took me 2 hours the first time i made it of hss when i tried it on turning blackwood it only lasted to cut 3 faces before it became blunt i had to replace it with a carbide one wich took me another 3 hours the tool is only .050 wide and .500 long all tools are hand ground with diamond grinding wheels . And that is only one tool , the other on made in carbide is more complicated being l shaped the tip of the tool is only .079 wide while the body is .040 . Hope this helps. to turn a face takes about 59 seconds with mach 3 so total machining time 12 minutes and still that does not account for all the special jigs needed to hold and mark the positions of the faces.
Marcel