1
Mach4 General Discussion / Mach 3 Jog Mode in Step is Excruciating Slow
« on: September 30, 2020, 08:37:25 PM »
I am running Mach3 with a Warp9 Ethernet SmoothStepper and C25 BOB.
When I select the jog mode to Step and jog it is incredibly slow. I have the Jog Rate set to 100%.
When I jog using the keys or the buttons on the onscreen pendant in "Cont" mode it jogs at the correct speed.(3048 mm/min)
When I set it to "Step" it is moving incredibly slow.
What is going on? I had no problem before reinstalling the software after I switched my controller card to the Smoothstepper. I reinstalled it to have a clean setup for the smoothstepper.
Am I missing something?
Please help!!
Thank you
Mark
When I select the jog mode to Step and jog it is incredibly slow. I have the Jog Rate set to 100%.
When I jog using the keys or the buttons on the onscreen pendant in "Cont" mode it jogs at the correct speed.(3048 mm/min)
When I set it to "Step" it is moving incredibly slow.
What is going on? I had no problem before reinstalling the software after I switched my controller card to the Smoothstepper. I reinstalled it to have a clean setup for the smoothstepper.
Am I missing something?
Please help!!
Thank you
Mark