Hello Guest it is December 03, 2022, 07:59:53 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mspag

Pages: 1
General Mach Discussion / UC400ETH + PROMA THC 150 + MACH3
« on: September 29, 2020, 07:55:11 AM »
Hello, does uc400eth support realtime THC (Proma 150) via plugin in mach3?


General Mach Discussion / Re: XHC ethernet controller & PROMA 150 THC
« on: September 19, 2020, 04:53:17 AM »
Short answer NO.

Will replacing THC 150 with SD be a good idea?

General Mach Discussion / XHC ethernet controller & PROMA 150 THC
« on: September 18, 2020, 03:21:07 PM »
Hello, i buy purchased XHC MK3-ET controller and im having a problem.
I cannot get it to run THC in Mach3 Plasma mode.
Im using PROMA THC 150.
Mach3 is reading inputs in diagnostic(ARC OK, UP, DOWN) but Z axis doesn't move or when it does, its going random and passing min max values.
I read that cnc controller for that function should have a THC support.
Is it possible to write some kind of script/macro to get it running...

Pages: 1