Hello Guest it is March 28, 2024, 08:50:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jojocutter

Pages: 1
1
Mach4 General Discussion / Re: Mach4 Pokeys57cnc and Consew
« on: August 25, 2020, 06:02:10 PM »
Well done Mr. Waterworth.....you got me turned in the right direction... needed to get out of the feed per rev (G99) and Constant Surface Speed (G96) which both need spindle feedback and into Feed per min(G98) and Constant Speed (G97) which doesn’t.
I am now rippin chips thanks to you..
Cheers

2
Mach4 General Discussion / Mach4 Pokeys57cnc and Consew
« on: August 23, 2020, 10:58:32 AM »
Lathe works 98% up until the gcode calls for a linear feed.
Consew motor runs and is controlled independently of Mach4 through its own controller. Is there some way to override Mach4 into thinking it’s connected to the motor, as I assume it’s not moving because it does not detect any spindle speed?

Pages: 1