1
Mach4 General Discussion / Touch sensor mounted at side of spindle.
« on: August 19, 2020, 01:11:07 PM »
Hello,
is it possible to setup somewhere in Mach4 offets of touch sensor? I decided to mount my self made sensor not in spindle but at some offset (to have quick access to measure without changing tool). So what I want is to perform some calculation in TouchOf plugin to substract offsets.
Best regards C3l1n
is it possible to setup somewhere in Mach4 offets of touch sensor? I decided to mount my self made sensor not in spindle but at some offset (to have quick access to measure without changing tool). So what I want is to perform some calculation in TouchOf plugin to substract offsets.
Best regards C3l1n