Hello Guest it is March 28, 2024, 05:32:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - faypearse

Pages: 1
1
General Mach Discussion / Mach 3 Setup for a plasma CNC
« on: July 06, 2020, 09:34:02 AM »
HI

We have recently built a cnc machine for plasma cutting but are having a bit of a hard time setting up the mach 3 software to work. I cannot find much on the different options for setting up the motors, speed etc and how to do it.
I can get it to move forward , sideways and set the zero points but not sure where to set the size of the table and basically how it works any help would be greatly appreciated.

Thanks

Pages: 1