Messages

21

G-Code, CAD, and CAM discussions / Re: Joining G code HELP!

« on: January 07, 2008, 03:52:45 PM »

Hi Tony
 removing M30 did the trick .I am new to cnc and  will have to read up the section on code in the mach 3 manual.
Thanks for your help Bill and Tony .
Rob

22

G-Code, CAD, and CAM discussions / Re: Joining G code HELP!

« on: January 07, 2008, 12:03:31 PM »

Hi Bill
here is the file. mach only See's the first part.i found the nesting wizard i will have ago with it.
thanks rob

23

G-Code, CAD, and CAM discussions / Re: Joining G code HELP!

« on: January 06, 2008, 05:52:06 PM »

hi docltf
i have given it ago and mach3 dose not see the second part . no warp drive, what do i need to edit
Rob

24

G-Code, CAD, and CAM discussions / Re: Joining G code HELP!

« on: January 06, 2008, 03:37:59 PM »

HI docltf
 is it as easy as that .Thanks
Rob

25

G-Code, CAD, and CAM discussions / Joining G code HELP!

« on: January 06, 2008, 02:19:17 PM »

HI is it possible to join together two or more G code's if so can anybody help . i use Lcam to produce my code.
thanks Rob.

26

Show"N"Tell ( What you have made with your CNC machine.) / Re: iPod Nano Case

« on: December 30, 2007, 05:46:35 AM »

excellent work how long did it take to machine? is the case anodized?
Rob

27

Show"N"Tell ( What you have made with your CNC machine.) / Vice Stop

« on: December 28, 2007, 04:42:29 PM »

This is something i made to fit my small tool makers vice for repeatable work positioning . The stop can be removed and refitted if its in the way
for maching with no loss of position.
Rob.

28

Show"N"Tell ( What you have made with your CNC machine.) / Re: Steam Engine Name Plates

« on: November 26, 2007, 06:21:10 PM »

John see what you mean about VCarve 3D Gcode  brillant its a first for me. the definition of the lettering is excellent.theres is bit un- machined under the engineering but hey no matter it's practices.
 ground up a propper cutter for this one instaed of the quick off hand one i used earlyer.had to so down the feed rate as my mill only dose 4300rpm what mill do you have which has 8000rpm?
i will have too redo my earlyer efforts.
Thanks Rob.

29

Show"N"Tell ( What you have made with your CNC machine.) / Re: Steam Engine Name Plates

« on: November 26, 2007, 11:45:18 AM »

John, cheers for the code i will post the results. i down loaded V Carve trial whats the limitations on the trial version?
thanks
Rob

30

Show"N"Tell ( What you have made with your CNC machine.) / Re: Steam Engine Name Plates

« on: November 25, 2007, 12:06:10 PM »

Hi John that was quick no 60mm by 22mm will check my settings . would it be better if i did it in inches?