Messages

1

PoKeys / Re: Single button for Jog Mode

« on: February 06, 2012, 10:36:02 AM »

Thanks so much for the answer, I never used the brain in my life.

Do not take me around for this. I do not know where to start, now I'll try some on wiki. I am a bad software engineer!

Thank you very much for your suggestion.

If anyone have any info about it would make me very comfortable.
Even percheè once resolved could do the same for the choice of the "cycle jog step."

The Wiki hot key is indicated this

1024.set (Mill)    Toggle Jog Mode Through Cont/Step/Step Velocity/Velocity Only    Ctrl J    32842    0x804a    50

but pressing Ctrl and J nothing to do!

Gionata

2

PoKeys / Single button for Jog Mode

« on: February 06, 2012, 09:52:32 AM »

Hi, I bought a couple of pokey 56u to use on my cnc, how can I use a single button to select the various types of jog mode, in practice I would make sure that the touch of a button you can change the different modes of operation. All this is to not use a rotary switch but one.
I hope I was clear in explaining

Thanks

3

General Mach Discussion / problem whit mach3 and gcode

« on: October 31, 2011, 06:22:45 PM »

Hi, I'm an Italian boy, struggling with his first CNC.
A friend passed me a version of Mach3 to try it, I tried the first version of linux emc but too difficult to understand and set.
But I had problems with with gcode Mach3.
I installed the Mach3 R3.042.040 Artsoft. Genero Artcam files (I tried different types of export art cam but the result is not changed.) In practice, if I check my gcode with a notepad is ok (eg 600 lines of code), including controls at the end of the cycle.
The problem is that when I load the gcode in the same gcode Mach3 is not seen in the code window and if I send the machine in the works, it works for some past then stops as if the code is broken.
In fact I see in the gcode in the left window of the main screen of Mach3 does not end at the end with the classic controls spindle stop and return to home as I took in the gcode, but ends in any position of the code.
Then skim the gcode if I see that it is incomplete.
I tried this on two different computers, I also tried to download a version from the internet "not exactly legal" but only for testing, I want to be sure you buy a working product. The machine is a machine that I use intel cor 2 duo with 2gb of ram, and then recently I do not think that is attributable to the machine itself.
Can anyone help me?. If I get guaranteed support and operation of the software are also ready to buy immediately.

Thanks

Gionata