1
Mach4 General Discussion / Re: Mach 4 with PMDX-126 and ESS proximity switches
« on: July 15, 2020, 12:45:57 PM »
Thank you so much for the reply, yea I am still dead in the water, going to work on it today. I purchased this machine off of someone so I know the pins are correct from what I can tell, its the config that I do not have. So basically I have no Z sensory, a gantry left and right sensor which homes right. I have a Y on back left and back right and it is the back right that is not stopping it because when I launch home the gantry stops at the back left and the right side still keeps going and click. (This is slave and pin 13) The one in the front I have not been able to test yet of course.
Anyway you can post your screenshot so I can check mine?
Anyway you can post your screenshot so I can check mine?
The Avid machine uses Warp9 ESS. If you have PMDX USB that system with Mach4 Homes using the same standard Homing, Z up to top and hits switch and then back down off it, then X to the left same as above and finally to the Y Home front left. If your Y is Homing to the back it needs to be reversed in the Configuration setup pin setting. Your Jog buttons should be setup correctly when you change that, so Homing will work.
The PMDX is what I use and there is documentation on that website, also the guy who owns that business is on here.
There are a lot of folks on here with much more experience than me I do not know why they did not reply??